Your routine
Always run filtration while adding products and wait 30 minutes between each. Test at least weekly.
Every week
Filtration running, 30 minutes between each product.
- Sanitiser60 ml
- Shock20 g
- Cleanser60 ml
- Minerals50 ml
- Filter CleanerSpray, 15 min, hose
Every top-up
Tap water can carry chlorine.
- Chlorine Remover13 ml
Every month
Bio-film lives in pipes and filters too.
- Bio-Cleaner250 ml
Every 3 months
Or before you fully drain.
- Pipe Cleaner250 ml
Shown for a 1000 L bath. Set your litres above to personalise. Source: Clear As Ice General Maintenance & Step by Step Guide.
Starting a new bath?
- 1
Know your litres
Every dose depends on it. Check your bath's user guide or ask the manufacturer.
- 2
Fill and start filtration
Filtration runs every time you add a product.
- 3
Chlorine Remover
12.5 ml per 1000 L. Run filtration 30 minutes, then test with strips.
- 4
Total alkalinity first
18 g Alkalinity Increaser per 1000 L raises TA by 10 ppm. No more than 40 g per 1000 L at a time, 30 minutes between additions.
- 5
Then pH
Too high: 43 g pH Reducer per 1000 L lowers pH by 1 unit. Too low: 18 g Alkalinity Increaser per 1000 L raises it by 1 unit.
- 6
Then calcium hardness
10 g Hardness Increaser per 1000 L raises hardness by 10 ppm. Run filtration 30 minutes.
- 7
Sanitiser
60 ml per 1000 L. Run filtration 30 minutes. Do not overdose.
- 8
Minerals, if you use them
50 ml per 1000 L. Run filtration 30 minutes.